# BTT SKR 1.4 Turbo unable to connect to Pi/Octopi/Klipper

**URL:** <https://klipper.discourse.group/t/btt-skr-1-4-turbo-unable-to-connect-to-pi-octopi-klipper/7919>\
**Category:** General Discussion\
**Created:** [April 19, 2023, 2:19am UTC](https://klipper.discourse.group/t/btt-skr-1-4-turbo-unable-to-connect-to-pi-octopi-klipper/7919 "2023-04-19T02:19:16Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Sineos](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/sineos/32/18_2.png) [@Sineos](https://klipper.discourse.group/u/Sineos)\
**Post date:** [April 19, 2023, 7:13am UTC](https://klipper.discourse.group/t/btt-skr-1-4-turbo-unable-to-connect-to-pi-octopi-klipper/7919/2 "2023-04-19T07:13:51Z")

</div>

For a general SKR1.4(T) config see [https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-v1.4.cfg](https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-v1.4.cfg)

For some general troubleshooting tips see: [How-To Trouble-Shoot](https://klipper.discourse.group/t/how-to-trouble-shoot/6326)

> [@Neogenesis](#):
>
> Klipper\_lpc1769\_1C10011425813AAFCED76B5CC22000F5-if00: [Errno 2] No such file or directory: ‘usb-Klipper\_lpc1769\_1C10011425813AAFCED76B5CC22000F5-if00’

This indicates that your `[mcu]` either is wrong or your board is not correctly flashed / connected. The `[mcu]` section must match the output of `ls /dev/serial/by-id/*`

---

_[View the full topic](https://klipper.discourse.group/t/btt-skr-1-4-turbo-unable-to-connect-to-pi-octopi-klipper/7919)._