Building SV08 Max

General Discussion
1

Basic Information:

Printer Model: snapmaker sv08 max
MCU / Printerboard: unk
Host / SBC probably a bananapi-m5
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there snapemakeer SV08 maxm the biggun.

Describe your issue:

Assemble instructs wrong.???

Trying to install step 1. legs seem to jam about 1/4” low. screws don’t reach/match. Pix very confusing. Removed the corner blocks, as instructed, still don’t fit. Ideas? Thanks, Gene

new software here, took me two weeks to find it after changes, search engines about as usefull as tits on a boar hog, where has everybody gone???

2

This forum is probably not the best place to look for assistance on assembling a “brand name” printer.

Try Sovol SV08 MAX - Sovol3d forum

Sovol also has a discord channel if you search.

Good luck.

2 Likes
3

This forum is probably not the best place to look for assistance on assembling a “brand name” printer.

Try Sovol SV08 MAX - Sovol3d forum

Sovol also has a discord channel if you search.
The discord search couldn’t find it, it can’t even find the klipper
channel. But at least I’m getting bookmarkable URL’s here, thank you Dave.

Good luck.

Visit Topic or reply to this email to respond.

To unsubscribe from these emails, click here.

Cheers, Gene Heskett, CET.