# Classic timeout during probe

**URL:** <https://klipper.discourse.group/t/classic-timeout-during-probe/16556>\
**Category:** General Discussion\
**Created:** [May 18, 2024, 11:26am UTC](https://klipper.discourse.group/t/classic-timeout-during-probe/16556 "2024-05-18T11:26:52Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![NegativeFate](https://avatars.discourse-cdn.com/v4/letter/n/c4cdca/32.png) [@NegativeFate](https://klipper.discourse.group/u/NegativeFate)\
**Post date:** [May 18, 2024, 11:26am UTC](https://klipper.discourse.group/t/classic-timeout-during-probe/16556/1 "2024-05-18T11:26:52Z")

</div>

### Basic Information:

Printer Model: voron 2.4  
 MCU / Printerboard: stm32f446  
 Host / SBC btt pi  
 klippy.log  
[klippy (21).zip](https://klipper.discourse.group/uploads/short-url/v8qLKyA4jGgLhvvzD52HnxdT1k2.zip) (4.4 MB)

hey all, hate to beat on this old drum but i “think” ive tried everything short of a total reset or dirtying the klipper install.

according to some, the idea of noise on the can lines could have an impact so i have shielded and grounded those, slowed homing all the way down, ran a probe accuracy, have no bytes retransmit or invalid.

literally the only thing i did to start this off was swap out to a 0.6 nozzle and run a pid

if anyone has had some success.. im paying attention

please and thankyou.

---

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/free1/uploads/klipper/original/1X/64419bf2aac6639e6ef5cef200dcd456b0a01ac3.png) [@system](https://klipper.discourse.group/u/system)\
**Post date:** [July 17, 2024, 11:26am UTC](https://klipper.discourse.group/t/classic-timeout-during-probe/16556/2 "2024-07-17T11:26:55Z")

</div>

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.