Basic Information: NEED HELP WITH Klipper ISSUE
Printer Model: Ender 6
MCU / Printerboard: /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0
Host / SBC ender6
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
… Hey everyone, i am new to the 3d printing. i bought a second hand 3d printer but have ran into a issue that i cant seem to fix.
Endstop stepper_x still triggered after retract**.**
if anyone can offer some advise it would be greatly appreciated. i have attached the Klippy log if anyone can take a look and offer advise. I currently had to fall back on using the ender 3 to complete the 3d printing task for autism camp and have fallen way behind on the amount of camp keychains that i have to get done.
Any assistance is welcome.
klippy.log (3.2 MB)