# Enhanced delta calibration - guidance or alternative?

**URL:** <https://klipper.discourse.group/t/enhanced-delta-calibration-guidance-or-alternative/5515>\
**Category:** General Discussion\
**Created:** [December 23, 2022, 8:11am UTC](https://klipper.discourse.group/t/enhanced-delta-calibration-guidance-or-alternative/5515 "2022-12-23T08:11:18Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![goosst](https://avatars.discourse-cdn.com/v4/letter/g/dc4da7/32.png) [@goosst](https://klipper.discourse.group/u/goosst)\
**Post date:** [December 23, 2022, 8:11am UTC](https://klipper.discourse.group/t/enhanced-delta-calibration-guidance-or-alternative/5515/1 "2022-12-23T08:11:18Z")

</div>

### Basic Information:

Printer Model: tripodmaker  
 MCU / Printerboard:  
 `klippy.log`  
[klippy.log](https://klipper.discourse.group/uploads/short-url/r9doIKsH3nXJHNTxF1lRKb407vJ.log) (8.4 KB)

### Describe your issue:

Is there a way to “guide” the enhanced delta calibration to get better dimensional accuracy on a delta printer? Or is there an alternative calibration method, I don’t have good results with the default method.

In between run 1 and run 2 was a “DELTA\_ANALYZE CALIBRATE=extended”, it only seems to improve the spoke length but not much else. There is a large amount of variation (skewed pillars, not ok outer distances, …) which doesn’t really change before and after.

 ![image](https://global.discourse-cdn.com/free1/uploads/klipper/original/2X/7/7fefa3fa08b2724108b8b8a040b4fa4e9c3873a6.png)

 ![image](https://global.discourse-cdn.com/free1/uploads/klipper/original/2X/2/246a553fe9c7b87a5b0e481ead42fc3af2c3c6bb.png)

 ![image](https://global.discourse-cdn.com/free1/uploads/klipper/original/2X/4/43c1d45438bd5fb141f5e5f168c0c847305034d6.png)  
 ![image](https://global.discourse-cdn.com/free1/uploads/klipper/original/2X/f/f9123aac3c844339810d2b9f212617ecc6120677.png)

---

<div class="post-metadata">

**Author:** ![EddyMI3D](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/eddymi3d/32/1981_2.png) [@EddyMI3D](https://klipper.discourse.group/u/EddyMI3D)\
**Post date:** [July 1, 2026, 4:08am UTC](https://klipper.discourse.group/t/enhanced-delta-calibration-guidance-or-alternative/5515/2 "2026-07-01T04:08:50Z")

</div>