# Extruder below minimum temp error

**URL:** <https://klipper.discourse.group/t/extruder-below-minimum-temp-error/17708>\
**Category:** General Discussion\
**Created:** [July 17, 2024, 12:29am UTC](https://klipper.discourse.group/t/extruder-below-minimum-temp-error/17708 "2024-07-17T00:29:07Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Granulka](https://avatars.discourse-cdn.com/v4/letter/g/f4b2a3/32.png) [@Granulka](https://klipper.discourse.group/u/Granulka)\
**Post date:** [July 17, 2024, 12:29am UTC](https://klipper.discourse.group/t/extruder-below-minimum-temp-error/17708/1 "2024-07-17T00:29:07Z")

</div>

### Basic Information:

[u] Printer Model: Sovol SV06  
[u] MCU / Printerboard: STM32F103  
[u] Host / SBC : Raspberry Pi 4  
[u] klippy.log  
[klippy.log](https://klipper.discourse.group/uploads/short-url/uGvWBMLw6qTurL4HB3SnDOsbTHj.log) (3.5 MB)

### Describe your issue:

After starting print, printer performs heatup and homes then shows error  
`Your printer's firmware reported an error. Due to that the ongoing print job will be cancelled. Reported error: Extrude below minimum temp`

If i start print again it starts normaly.

how can i fix it ?

---

<div class="post-metadata">

**Author:** ![Sineos](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/sineos/32/18_2.png) [@Sineos](https://klipper.discourse.group/u/Sineos)\
**Post date:** [July 17, 2024, 4:09pm UTC](https://klipper.discourse.group/t/extruder-below-minimum-temp-error/17708/2 "2024-07-17T16:09:48Z")

</div>

In the first place it looks like that you are using a slicer start gcode that is not compatible to Klipper

- It seems to include only `M104` command and no `M109`, which leads to Klipper not waiting until fully heated up
- Various other commands that are not known / not used Klipper

In addition there seem to be issues with your stepper drivers that are showing error conditions, but this is a different story.

---

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/free1/uploads/klipper/original/1X/64419bf2aac6639e6ef5cef200dcd456b0a01ac3.png) [@system](https://klipper.discourse.group/u/system)\
**Post date:** [September 15, 2024, 4:10pm UTC](https://klipper.discourse.group/t/extruder-below-minimum-temp-error/17708/3 "2024-09-15T16:10:01Z")

</div>

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.