Getting a stepcompress error and printer shuts down during mesh calibrate

General Discussion
1

Basic Information:

Printer Model: E3V2
MCU / Printerboard: SKR mini e3 v3
klippy (7).zip (709.7 KB)

klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…
Internal error in stepcompress

Internal error on command:“BED_MESH_CALIBRATE”
Once the underlying issue is corrected, use the
“FIRMWARE_RESTART” command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown

Gets about 5-7 points in for mesh calibration then pops this error

2

Update to latest git. The version v0.11.0-303-g67499853 is buggy

3

Awesome, I will make sure I update git. I took out the input shaping in the cfg and that fixed it too. I should have not had it in there to begin. With since I don’t have an accelerometer

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.