# Getting orange pi 3 lts + klipper working with anycubic kobra 2 neo

**URL:** <https://klipper.discourse.group/t/getting-orange-pi-3-lts-klipper-working-with-anycubic-kobra-2-neo/11278>\
**Category:** General Discussion\
**Created:** [October 31, 2023, 8:47am UTC](https://klipper.discourse.group/t/getting-orange-pi-3-lts-klipper-working-with-anycubic-kobra-2-neo/11278 "2023-10-31T08:47:21Z")\
**Posts on this page:** 1\
**Showing post:** 43

<div class="post-metadata">

**Author:** ![Sineos](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/sineos/32/18_2.png) [@Sineos](https://klipper.discourse.group/u/Sineos)\
**Post date:** [December 23, 2023, 8:47am UTC](https://klipper.discourse.group/t/getting-orange-pi-3-lts-klipper-working-with-anycubic-kobra-2-neo/11278/43 "2023-12-23T08:47:07Z")

</div>

> [@robertocrr](#):
>
> Did I not waited long enough? How to tell?

General things to mind:

- Use SD cards below 8GB, some boards do not like bigger cards
- The command `ls /dev/serial/by-id/*` needs to show the board
- The [dmesg procedure](https://klipper.discourse.group/t/how-to-trouble-shoot/6326) should not show any errors around the board’s USB device
- As long as no display section is properly configured in the printer.cfg and Klipper has connected, the display will stay blank

---

_[View the full topic](https://klipper.discourse.group/t/getting-orange-pi-3-lts-klipper-working-with-anycubic-kobra-2-neo/11278)._