KlipperScreen: Z Axis inverted

General Discussion
1

Basic Information:

Printer Model: LDO Trident 300mm
MCU / Printerboard: Octopus v1.1

PXL_20230304_044125308~2
PXL_20230304_044125308~21920×1762 195 KB

Describe your issue:

I am not sure where to post this.
So everything is working fine but when I go to Actions > Move, the Z is inverted.
Z- is increasing the distance while Z+ is decreasing it and I would end up causing a crash.
Fine tune is correct so it must be something that went wrong.

I installed it via Kiauh

2

As it is about Klipper Screen, the sub forum would be Frontends.

Have you checked the assignments in the Klipper Screen setup?

3

This is all new to me, I just create a config that sets the temps for the filaments, I might need to check what I am missing or need to fix.

1 Like