# Out of range error -- no BLTouch

**URL:** <https://klipper.discourse.group/t/out-of-range-error-no-bltouch/4904>\
**Category:** General Discussion\
**Created:** [November 11, 2022, 8:34pm UTC](https://klipper.discourse.group/t/out-of-range-error-no-bltouch/4904 "2022-11-11T20:34:02Z")\
**Posts on this page:** 1\
**Showing post:** 8

<div class="post-metadata">

**Author:** ![Sineos](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/sineos/32/18_2.png) [@Sineos](https://klipper.discourse.group/u/Sineos)\
**Post date:** [November 12, 2022, 8:02am UTC](https://klipper.discourse.group/t/out-of-range-error-no-bltouch/4904/8 "2022-11-12T08:02:29Z")

</div>

> [@jrobbom5](#):
>
> Try putting these two lines in the [extruder] section of your config file
> 
> ```auto
> max_extrude_only_distance: 150.0
> max_extrude_cross_section: 100
> 
> ```
> 
> Those numbers are probably too large, but it will prevent that error from accuring

Please do not share such advice. In 99.99% this is not needed for a standard setup. If such errors occur, then there is a reason for it that may be causing other issues as consequence.  
Setting this will only mask the actual problem. Also see [[H] Move exceeds maximum extrusion - #2 by Sineos](https://klipper.discourse.group/t/h-move-exceeds-maximum-extrusion/1189/2)

---

_[View the full topic](https://klipper.discourse.group/t/out-of-range-error-no-bltouch/4904)._