# QGL, Z-Tilt, Bed Mesh and x-y probe offset

**URL:** <https://klipper.discourse.group/t/qgl-z-tilt-bed-mesh-and-x-y-probe-offset/26010>\
**Category:** General Discussion\
**Created:** [May 20, 2026, 10:13pm UTC](https://klipper.discourse.group/t/qgl-z-tilt-bed-mesh-and-x-y-probe-offset/26010 "2026-05-20T22:13:30Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![printicus](https://avatars.discourse-cdn.com/v4/letter/p/8e7dd6/32.png) [@printicus](https://klipper.discourse.group/u/printicus)\
**Post date:** [May 20, 2026, 10:13pm UTC](https://klipper.discourse.group/t/qgl-z-tilt-bed-mesh-and-x-y-probe-offset/26010/1 "2026-05-20T22:13:30Z")

</div>

### Basic Information:

Printer Model:  
 MCU / Printerboard:  
 Host / SBC  
 klippy.log

_Fill out above information and_ _ **in all cases attach your** _ **`klippy.log` _file_** (use zip to compress it, if too big). _Pasting your_ `printer.cfg` _is **not** needed_  
_ **Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there** _

### Describe your issue:

Not an issue, just asking to be shure I have the facts right.

I have two printers. A Voron 2.4 with a toolchanger and I just finished my SaladFork(mini Trident from Printer for Ants), both using classic Klicky-Probe. This means that the probe is offset from the nozzle. Now, from the begining, my Voron vas build with Klicky-Probe, so I dont have annother refference point.

What I noticed on my Voron is that the bed mesh takes into account the probe y offset, but QGL does not. I made marks with a marker on the buildplate for the probing points for QGL and bed mesh. For QGL the probing points(when doing QGL) are under the nozzle, and for the bed mesh are under the probe. The same now with my SaladFork with Z-Tilt and bed mesh.

Is this ok, or am I doing some settings wrong?

PS the log is from my SaladFork.

[klippy.log](https://klipper.discourse.group/uploads/short-url/iefdZcqJbLSGlIwSTJpZI0hmJd7.log) (64.9 KB)

---

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/free1/uploads/klipper/original/1X/64419bf2aac6639e6ef5cef200dcd456b0a01ac3.png) [@system](https://klipper.discourse.group/u/system)\
**Post date:** [July 19, 2026, 10:13pm UTC](https://klipper.discourse.group/t/qgl-z-tilt-bed-mesh-and-x-y-probe-offset/26010/2 "2026-07-19T22:13:39Z")

</div>

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.