Hmm, this is a bit strange:
-
Your error message is Rescheduled timer in the past
-
This is caused by your extruder stepper (look at the
i=
value and see above link):
-
Neither your PA value nor the stepper settings would indicate this, so I’m not sure what is happening
-
Try deleting
instantaneous_corner_velocity = 1 max_extrude_only_distance = 1400 max_extrude_only_velocity = 75 max_extrude_only_accel = 10000 max_extrude_cross_section = 99999
-
Set
pressure_advance_smooth_time = 0.01
to 0.04