# Support for Duet3 6HC

**URL:** <https://klipper.discourse.group/t/support-for-duet3-6hc/332>\
**Category:** General Discussion\
**Created:** [May 31, 2021, 4:34pm UTC](https://klipper.discourse.group/t/support-for-duet3-6hc/332 "2021-05-31T16:34:34Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Malaquitte](https://avatars.discourse-cdn.com/v4/letter/m/a9a28c/32.png) [@Malaquitte](https://klipper.discourse.group/u/Malaquitte)\
**Post date:** [May 31, 2021, 4:34pm UTC](https://klipper.discourse.group/t/support-for-duet3-6hc/332/1 "2021-05-31T16:34:34Z")

</div>

Hi all,

I have finished assembling my 4th printer based on a Duet3 6HC (Armv7E-M) and I would like to make it work with Klipper.  
I tried to install it but couldn’t find a good reference in menuconfig so I guess it’s not “yet” possible.

Is support for this motherboard planned soon ?

---

<div class="post-metadata">

**Author:** ![koconnor](https://avatars.discourse-cdn.com/v4/letter/k/aca169/32.png) [@koconnor](https://klipper.discourse.group/u/koconnor)\
**Post date:** [June 2, 2021, 5:45pm UTC](https://klipper.discourse.group/t/support-for-duet3-6hc/332/2 "2021-06-02T17:45:31Z")

</div>

I’ve seen some discussions on this board on Discord. However, I don’t know of any time frame for supporting this board. As I understand it, it requires a port of the micro-controller code to that new micro-controller.

-Kevin

---

<div class="post-metadata">

**Author:** ![Malaquitte](https://avatars.discourse-cdn.com/v4/letter/m/a9a28c/32.png) [@Malaquitte](https://klipper.discourse.group/u/Malaquitte)\
**Post date:** [June 2, 2021, 6:17pm UTC](https://klipper.discourse.group/t/support-for-duet3-6hc/332/3 "2021-06-02T18:17:53Z")

</div>

Thanks Kevin, fingers crossed !