# Sv06 probe issues
**URL:** https://klipper.discourse.group/t/sv06-probe-issues/8394
**Category:** General Discussion
**Created:** [May 14, 2023, 8:06pm UTC](https://klipper.discourse.group/t/sv06-probe-issues/8394 "2023-05-14T20:06:56Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@9183D](https://klipper.discourse.group/u/9183D)
#### Post date: [May 14, 2023, 8:06pm UTC](https://klipper.discourse.group/t/sv06-probe-issues/8394/1 "2023-05-14T20:06:57Z")
### Basic Information:
Printer Model: sovol sv06
MCU / Printerboard:stock sovol board
`klippy.log`
[klippy.log](https://klipper.discourse.group/uploads/short-url/kKypDZfyj2S6dsYnpJnHvgDSib0.log) (949.7 KB)
yesterday
after install i did a print worked great but when it finished i got an error Move out of range: 138.412 364.990 150.360 [13291.592] the nozzle was still touching the print. so i pull the print and home it and the print head crashed into the bed i had to shut the machine off. while it was off i manually lifted the z axis then turned it on and tried again using my finger to try and trigger the probe nothing.
i deleted my config file then downloaded a well known repo from github from bassamantor did a print same thing happened probe isnt working again after only 1 print.
---
### Author:  [@EddyMI3D](https://klipper.discourse.group/u/EddyMI3D)
#### Post date: [July 7, 2025, 7:07pm UTC](https://klipper.discourse.group/t/sv06-probe-issues/8394/2 "2025-07-07T19:07:07Z")