Basic Information: Printer Model: Voron 2.4r2 MCU / Printerboard: Octopus Host / SBC: Raspberry Pi 4 klippy.log - 2 failing logs attached, with respective gcode inputs. Describe your issue: I started getting the TTC error tonight and it seems to be consistently failing on the same layer even…

If you are on the most current git and experience this issue, you could try checking out the committ just before this change series, e.g.: sudo service klipper stop cd ~/klipper git checkout 293858c51fc51c998a046ba12c00da0418fb8403 sudo service klipper start

Timer too close - so far, two prints failing on the same layer, WTF?

General Discussion

EddyMI3D September 13, 2024, 11:40am 4

Hello @thisisit

On the same gcode files as the OP?

Topic		Replies	Views
Timer too Close on Voron 2.4 General Discussion	13	1312	April 24, 2024
"Timer too close" at specific point in a gcode General Discussion	9	280	July 23, 2024
Can a failing MCU cause 'bytes_retransmit' General Discussion	5	63	September 3, 2024
Klipper: "MCU 'mcu' shutdown: Timer too close" General Discussion	4	101	August 27, 2024
"Timer Too Close" at a consistent time in file General Discussion	7	453	April 21, 2024

Timer too close - so far, two prints failing on the same layer, WTF?

Related topics