# Timer too close, yet another. Pretty sure this is a bug

**URL:** <https://klipper.discourse.group/t/timer-too-close-yet-another-pretty-sure-this-is-a-bug/14115>\
**Category:** General Discussion\
**Created:** [February 14, 2024, 9:46pm UTC](https://klipper.discourse.group/t/timer-too-close-yet-another-pretty-sure-this-is-a-bug/14115 "2024-02-14T21:46:32Z")\
**Posts on this page:** 1\
**Showing post:** 9

<div class="post-metadata">

**Author:** ![Sineos](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/sineos/32/18_2.png) [@Sineos](https://klipper.discourse.group/u/Sineos)\
**Post date:** [February 15, 2024, 6:43am UTC](https://klipper.discourse.group/t/timer-too-close-yet-another-pretty-sure-this-is-a-bug/14115/9 "2024-02-15T06:43:32Z")

</div>

> [@lucan07](#):
>
> just spotted this may be relevant late now will look tomorrow [https://youtu.be/UNGrYuZdwXk?si=OYGQo49gHJZRZilN](https://youtu.be/UNGrYuZdwXk?si=OYGQo49gHJZRZilN)

See my answer at ['EBBCan': Unable to connect - After FW updates - #10 by Sineos](https://klipper.discourse.group/t/ebbcan-unable-to-connect-after-fw-updates/14107/10). Again, unrelated to this kind of error.

> [@Arakon](#):
>
> None of your points would explain why it fails ONLY in canbridge mode on the SKR3, and never in canbridge mode with the RP2040 or with an USB CAN adapter. The config is exactly the same.

This is an [error](https://klipper.discourse.group/t/timer-too-close/6634) due to timing mismatches between host and board.  
Even the slightest change in timing behavior can provoke this error. Unofficial modules MAY lead to such and are definitively a reason not to look further into such reports as it may be a total waste of time when finally the error is caused by such modifications.

---

_[View the full topic](https://klipper.discourse.group/t/timer-too-close-yet-another-pretty-sure-this-is-a-bug/14115)._
