# X endstop not working **URL:** \ **Category:** General Discussion\ **Created:** [February 10, 2023, 11:24am UTC](https://klipper.discourse.group/t/x-endstop-not-working/6551 "2023-02-10T11:24:37Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![Manu4619](https://avatars.discourse-cdn.com/v4/letter/m/f0a364/32.png) [@Manu4619](https://klipper.discourse.group/u/Manu4619)\ **Post date:** [February 10, 2023, 11:24am UTC](https://klipper.discourse.group/t/x-endstop-not-working/6551/1 "2023-02-10T11:24:37Z")
### Basic Information: Printer Model: Ender 3 v2 MCU / Printerboard: BTT manta M4p `klippy.log`[klippy.log](https://klipper.discourse.group/uploads/short-url/enSAcTmCQnwmaqW86CxRaffbXxY.log) (223.7 KB) ### Describe your issue: I have a fresh install on the ender 3 v2 running a manta m4p with the CB1. My issue is that i cannot seem to get my x-endstop to work. My y-endstop works and my z endstop is a bltouch which i haven’t tested yet. As far as i know, i have wired everything correctly (wires going to signal and ground) and i have set the correct pin on the “endstop\_pin:” (i have set the x endstop pin to “!^PC0”). I have uploaded my klipper log file. i’m not sure how to interpret it because i am new to klipper. any help woulld be greatly appreciated. ---
**Author:** ![EddyMI3D](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/eddymi3d/32/1981_2.png) [@EddyMI3D](https://klipper.discourse.group/u/EddyMI3D)\ **Post date:** [February 10, 2023, 1:28pm UTC](https://klipper.discourse.group/t/x-endstop-not-working/6551/2 "2023-02-10T13:28:17Z")
Hello @Manu4619 ! Have you checked the switch for functionality? ---
**Author:** ![Manu4619](https://avatars.discourse-cdn.com/v4/letter/m/f0a364/32.png) [@Manu4619](https://klipper.discourse.group/u/Manu4619)\ **Post date:** [February 18, 2023, 10:01am UTC](https://klipper.discourse.group/t/x-endstop-not-working/6551/3 "2023-02-18T10:01:13Z")
I have. I replaced the x endstop with the endstop that was for the y axis and it still doesn’t work. ---
**Author:** ![EddyMI3D](https://yyz2.discourse-cdn.com/free1/user_avatar/klipper.discourse.group/eddymi3d/32/1981_2.png) [@EddyMI3D](https://klipper.discourse.group/u/EddyMI3D)\ **Post date:** [December 18, 2024, 7:58pm UTC](https://klipper.discourse.group/t/x-endstop-not-working/6551/4 "2024-12-18T19:58:51Z")