# Z-axis not stopping when probe lights goes out

**URL:** <https://klipper.discourse.group/t/z-axis-not-stopping-when-probe-lights-goes-out/18708>\
**Category:** General Discussion\
**Created:** [September 8, 2024, 12:02pm UTC](https://klipper.discourse.group/t/z-axis-not-stopping-when-probe-lights-goes-out/18708 "2024-09-08T12:02:23Z")\
**Posts on this page:** 2\
**Page:** 2

<div class="post-metadata">

**Author:** ![Jasper](https://avatars.discourse-cdn.com/v4/letter/j/cdc98d/32.png) [@Jasper](https://klipper.discourse.group/u/Jasper)\
**Post date:** [September 9, 2024, 4:50pm UTC](https://klipper.discourse.group/t/z-axis-not-stopping-when-probe-lights-goes-out/18708/21 "2024-09-09T16:50:32Z")

</div>

I’ll do it, i also saw it yesterday but the corner of the bed works fine for me but i’ll put it at the middle.

any idea how to move the Z-axis down x mm because the Z-offset setting didn’t work after saving. the reason for this is because my probe triggers at 4mm no config possible for that

or does that apply when i start a print?

---

<div class="post-metadata">

**Author:** ![system](https://global.discourse-cdn.com/free1/uploads/klipper/original/1X/64419bf2aac6639e6ef5cef200dcd456b0a01ac3.png) [@system](https://klipper.discourse.group/u/system)\
**Post date:** [October 10, 2024, 2:50am UTC](https://klipper.discourse.group/t/z-axis-not-stopping-when-probe-lights-goes-out/18708/22 "2024-10-10T02:50:40Z")

</div>

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.

[Previous page](https://klipper.discourse.group/t/z-axis-not-stopping-when-probe-lights-goes-out/18708.md?page=1)