Basic Information: Printer Model: Ender 3 Pro MCU / Printerboard: Makerbase MKS Skipr Mk1.0 klippy.log Describe your issue: After testing my 3dtouch with BLtouch debug commands and confirming the board is reading the control pin proper I try to run G28 to home the bed. the problem is now when…

Turned out i needed pin_up_reports_not_triggered: to be set to True for this probe to work correctly, This topic can be closed, thanks everyone for the help.

How about sharing your klippy.log, as you were asked when you put in the information?

I don’t know if this is your problem (I don’t have a klippy.log to look at) but you can’t read the temperature of TMC2209s. I’m not sure what the temperature_sensor statements like: [temperature_sensor tmc2209_stepper_x] sensor_type: temperature_host min_temp: 10 max_temp: 100 Are doing exactly, …

My apologies i forgot to attach it when i posted, Also regarding the 2209 temp outputs it seems to be working as i’m getting a reading about 9c above ambient whille at idle, and the MCU and HOST readouts are both accurate to what i have seen in SSH however i may be completely wrong being new to klip…

temperature_host is for reading the temperature of the host as it says. This means you want to read the temperature of the SBC (single board computer like RasPi). Check this for further explanation: https://www.klipper3d.org/Config_Reference.html?h=temperature_host#host-temperature-sensor Althou…

Removed lines involving driver temps, leaving just SBC and MCU. 3dtouch behavior still remains non functioning.

Have you checked this one? BL-Touch - Klipper documentation also this: [image] 3DTouch G28 issue General Discussion Basic Information: Printer Model: Ender 3 MCU / Printerboard: SKR Pro 1.1 with TMC2208 klippy.log k…

3D Touch probing false deploy when safehoming

General Discussion

EddyMI3D October 20, 2023, 9:11am 7

Have you checked this one?

also this:

Topic		Replies	Views
[bltouch clone] ender 3v2 cannot home General Discussion	1	117	December 19, 2024
BLtouch wont perform Home after first print. Z will move anyway General Discussion	4	303	April 24, 2024
How can be add that the Software check in the 3d Touch is deployed for homing General Discussion	29	134	March 14, 2026
BLtouch + Creality 427 on Ender 5 General Discussion	9	3725	August 28, 2025
3DTouch G28 issue General Discussion	3	540	October 20, 2023

3D Touch probing false deploy when safehoming

Related topics