Axis move more than they should

General Discussion
1

Basic Information:

Printer Model: ender 3 pro 2020
MCU / Printerboard: btt skr mini e3 v3.0
Host / SBC rpi 4
klippy.log

klippy.log (1.3 MB)
printer.cfg (18.4 KB)

Describe your issue:

…
When i try to home it will move to my described x100 y100 but irl that location is about x 190 and y 0
,i had same microsteps and rotation_distance as on previous board creality 4.2.2 , i only changed board, installed klipper on it and edited config as described on BTT github
Endstop_pin is detected when i use m119 command
Not sure what to do next but thanks for any help

2

Welcome BorisProtogen,

don’t know. Did you try Welcome! | Ellis’ Print Tuning Guide

Good luck, hcet14

3

Fixed it, forgot to include tcm… part of conf

1 Like