Bed mesh doesn't compensate with a 0.1375 deviation

General Discussion
1

Basic Information:

Printer Model: EnderWire
MCU / Printerboard: SKR Mini E3
klippy.log klippy(11).log (1.5 MB)

Describe your issue:

Just finished building my EnderWire.
using CR-Touch to probe the bed and it looks like i am getting a good probe.

the bed mesh shows that the right side of the bed is a bit lower and i assuming that it will adjust to it, but from the square test it looks like no adjusting is done.

the bed mesh looks like this:

image
image1185×645 53.2 KB

the square test looks like this:

Untitled
Untitled980×2016 304 KB

Untitled-1
Untitled-1980×2016 428 KB

Untitled
Untitled980×2016 400 KB

i would really appreciate any help or ideas :pray:

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.