If you are interested, I can add topics that I stumble upon here in the thread, for example:
- No x/y offsets in the [probe] section → Tilt and bed besh don't seem to correlate
- For [probe] sections it should be a warning
- For [bltouch] sections an error
- Wrong format of the serial → Da Vinci MCU unable to connect - #9 by EleriLove
- A bit tricky, e.g. Issues flashing the printer board
- Sometimes,
/dev/serial/by-id/or/dev/serial/by-path/is omitted - MCU Connection issue after flashing ADXL345 v2.0
- Having certain sections multiple times: Unable to save printer.cfg, log shows old config after "save and restart"
- Blanks in fron to settings where no blanks belong: SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value - #11 by Sineos
enable_pinnot inverted, multiple endstop definitions: Why Won't my Z Steppers Move?- Wrongly set mesh boundaries: Move Out Of Range Issue pls help - Bed Mesh Calibrate
Just as a first start.