Basic Information:
Printer Model: Voron Trident
MCU / Printerboard: SKR 3 v3 / EBB36 v1.2
Hello, I’m rebuilding my Trident and I’m looking to use an SKR 3 board with an ebb36 v1.2, I was thinking to connect them with USB cable instead of CAN, but I don’t find to much info regarding this, I’ve flashed the EBB36 with the firmware_USB.bin found on GitHub, and I’ve created the config file for the SKR according to Klipper documentation.
Is there somebody who could describe the steps, or point out a good instalation guide.
Thanks!