Help Bltouch delta printer

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Hello, I’m trying to set up Bltouch on a rumba board, the machine is a Delta Kossel Mini, I can’t configure in firmware to make it work. Would anyone be so kind as to help me?
…

2

Hello @Marck93c !

Any klippy.log?

Please attach it to your next post.

You may also see this thread regarding a BLTouch on a Delta Printer.

3

klippy (3).log (1.4 MB)

Thanks for the reply, I’m very ignorant but I’m trying anyway to make this machine work. The bltouch, when I turn on the machine, lights up red and the tip goes up and down, but if I try to send some commands nothing happens

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.