Klipper Firmware Fails to Start on Custom STM32F070 Board

[mykepredko]

Heya,

I don’t know if you’ve been following this thread:

Trying to build Firmware for STM32F070x6

I hope this is the right category for this issue. I have been working at setting up the make menuconfig firmware process for the STM32F070x6. I have developed a small board using this MCU and I got samples in this week. This was discussed here: Klipper Firmware Fails to Start on Custom STM32F070 Board The first order of business was to modify ~/klipper/src/stm32/Kconfig to support the MCU and I did that and I believe that it is producing the correct .config file for the Klipper Firmware Buil…

Could you try out the patch that @koconnor came up with for the STM32F070x6?

I’ve just done it for my board and it works quite nicely with the USB interface.