Load_cell section is not valid Error

General Discussion
1

Basic Information:

Printer Model:Cartesian
MCU / Printerboard:skr pro 1.2
Host / SBC Mainsail
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I have my hx711 loadcell sensor and i wanna setup it .but i have problem
I added load_cell section in the printer.cfg but after saving and reseting the klipper it says : load_cell section is not valid
my klipper version is 0.13 and its up to date.
I tested the sensor seperately in seperate script in mainsail and it is fine

klippy (2).log (7.2 KB)

2

Hello @5axis3dprinter !

Have you tried with a pristine Klipper?

3

what do you mean?

Installing klipper from scratch?

4

Git version: ‘v0.13.0-223-geec81683e-dirty’

5

Actually i didnt reinstalled that version .instead i used your chat .i understood some files like load_cell.py in extras and … are missing
I copied and pasted one by one and problem fixed
Thank you for your help

2 Likes