- I’m not sure what
printer.base.cfgis meant to be, but your installation expects the config file to be/root/printer_data/config/printer.cfg. Also see Klipper’s printer.cfg - Syntax and Parsing Rules - You seem to be running Klipper under the root user. This is strongly discouraged for many reasons.
- There are quite a few settings, including
[verify_heater], that reduce Klipper’s sanity checks to the point where they become meaningless, potentially even allowing catastrophic failures. Usually, none of these are necessary and often indicate additional issues. - Your “load cell” is reporting a temperature of 340 °C.