Basic Information: Printer Model: Anycubic Kobra Plus MCU / Printerboard: klippy.log klippy(5).log (19.8 KB) So i had a hell of a time getting klipper up and running on this printer but thanks to someone on here whose name i cant remember but when i do i will mention him. anyways i had klipp…

Sineos was ol buddys name by the way. thanks to him

[image] Sineos: Good chance that you killed your board. Yep. Most of us have been there. I’ve got three nonfunctional boards in my parts cabinet that I carelessly fried by doing stuff that I still think shouldn’t have fried them. I’ve been over them several times with a magnifying glass and c…

so would either of yall know which board i should go with for the kobra plus printer ive looked at the bigtree skr mini e3v3 and the m5p but i really dont need a cb1 or the likes cause i have a 8gb raspi. what would be most compatable for my printer or is this a sort of thing like removing the brai…

There are so many boards out there, so it is really hard to make a solid reccomendation. For the Anycubic Kobra Plus you will need 5 drivers: X, Y, Z1, Z2, E The Mini E3V3 has 5 ports but the two Z ports are supplied by the same driver. While it works, I do not like this setup and rather prefer de…

[image] daronfritts: so would either of yall know which board i should go with for the kobra plus printer I’m not familiar with these printers but I looked at the stock board on the Anycubic website and it looks like there probably isn’t a simple drop-in replacement other than another stock b…

Just an update. The board wasn’t smoked somehow luckily. I am able to run klipper again. I’ve installed the bl touch and got the config file to accept it. I’m running all this on a modified kobra plus. I’ve disconnected the z endstop and used that to wire in part of my touch and the other part off t…

Might have smoked my motherboard

General Discussion

Sineos January 4, 2024, 9:18am 3

Follow the dmesg instructions and post the resulting file.

Good chance that you killed your board.

Topic		Replies	Views
Load Klipper on generic mother board? General Discussion	3	110	May 23, 2025
MCU Connection Error, Kobra 1 Plus, TriGorilla ProB General Discussion	9	486	December 1, 2024
Klipper Crashing on Tronxy X5SA 400 Pro with CXY-V6-191121 Board General Discussion	8	2011	March 11, 2024
How to support the Anycubic Kobra boards? Developers	3	6679	April 2, 2023
Anycubic Kobra Neo - Connection issue General Discussion	47	1276	April 25, 2025

Might have smoked my motherboard

Related topics