Moonraker won't come up properly

[mykepredko]

I’m still having weirdness with the install (doing yet another right now). Any idea when the push will come through?

---

What I thought would be a simple action (erasing the Flash and then loading in Klipper/Katapult) for:

Trying to use Katapult with a serial connection

Basic Information: Printer Model: Sapphire Pro MCU / Printerboard: BTT SKR Mini V3.1 Host / SBC: Orange Pi Zero 2W (Running Debian 6.1.31) klippy.log (55.6 KB) I am trying to get Katapult to work with a serial connection and I’m getting a strange response when I run the flashtool.py application, trying to Flash Klipper into the MCU. The steps I’m following once the Orange Pi boots and I can SSH into it are: Enable UART0 by adding the line “overlays=uart0” to /boot/orangepiEnv.txt" …

Has turned into two days of work with no end in sight.

I was able to get the ST-Link V2 working with relatively few problems - if anybody cares, the Linux version doesn’t seem to work with Ubuntu 24.04 LTS but it works fine under Windows 10.

So, I have a process where I can erase everything in the (STM32G0B1) MCU, load it from the Raspberry Pi zero 2W - now I just need to get Klipper working again.