Need help :printer.cfg is recover by auto and cant reboot

General Discussion
15

Your printer.cfg is a raging mess. It would make sense to:

  1. Familiarize yourself with the settings and documentation. Another starting point may be Klipper’s printer.cfg - Syntax and Parsing Rules
  2. Start over and build a clean config
  3. Respect warnings like #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated. if you do not know what you are doing.

Not sure if I cleaned up everything, but try
printer.cfg (42.7 KB)

  • It is expected to be in /home/orangepi/printer_data/config/printer.cfg.
  • Replace the file and then restart Klipper
  • Redo z_offset calibration and potentially PID tuning