Need help with Klipper

Basic Information:

Printer Model Tronxy x5sa
MCU / Printerboard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:


I have hit a brick wall . I have never messed with klipper only marlin pre VScode .
I pick this printer up dirt cheap being the board was bad . I had a BTT octopus v1.0 already . I am wanting to try Klipper this time . I have read up but I am still confused on how to set it up . Is there any good sources that will walk me through it step by step . Or is there anyone of you that might be interested in helping me learn the process