Problem with CANBUS during print/idle

[NAPCAL]

Did you redo the firmware on the Octopus, so it is not a CAN bridge but just on the CAN bus?

Also, make sure you look through the development posts while testing the Klipper bridge.

Experimental "USB to CANbus bridge" mode

I’ve created a new development branch that enables a micro-controller to simultaneously run Klipper and act as a “USB to canbus” adapter. This may be useful for users that have a canbus enabled mainboard and are running a canbus based toolhead board. In that case, this development branch may remove the need for a separate usb to can adapter. Some boards may also be able to add an external canbus transceiver, which again may reduce the need for a usb adapter. Finally, the branch may be useful…