QGL behaviour on a Voron350

General Discussion
36

I replaced my old microswitch from the Klicky Probe and Voila! convergence is more than perfect. So finally it was a bad (damaged) probe.

OK, Thanks all for the contribution. I’d like to continue the conversation about QGL and Z-Tilt in the Feature Section, if there is interest in. What I want to do is to change back from “NG Klicky Probe” to normal “Klicky Probe”, if I got some spare time (never).

QGL Convergence new
QGL Convergence new995×656 14 KB

EDIT: This is the repeatability of the new micro switch (again: 0,10€/part). Standard deviation is 0,004mm which should be good enough for my case (Hey REXT3D: Should I try the 0,005 again? :wink:)

09:20:25  // probe at 300.000,275.000 is z=7.464237
09:20:27  // probe at 300.000,275.000 is z=7.467987
09:20:28  // probe at 300.000,275.000 is z=7.467987
09:20:29  // probe at 300.000,275.000 is z=7.471737
09:20:30  // probe at 300.000,275.000 is z=7.475487
09:20:31  // probe at 300.000,275.000 is z=7.474237
09:20:32  // probe at 300.000,275.000 is z=7.474237
09:20:34  // probe at 300.000,275.000 is z=7.476737
4 Likes