Hi,
A question for @mykepredko (and everyone else).
I followed the MKS Monster instructions as linked above and all went as shown until it came to connecting the ebb36 board via the rj11 cable and got no such device exists. So I have a setting wrong somewhere.
So the MKS instructions for the CanBoot config shows communication interface as USB on PA11/PA12 but @NAPCAL’s reply shows this via Canbus on PD0/PD1. I went with the USB interface, is this correct?
I assumed that the MKS instructions referring to PA8/PA9 becomes PD0/PD1 on the Octopus Pro, but the Bigtreetech ebb36 github lists PB0/PB1?