Basic Information:
Printer Model: Prusa i3 Mk3S+
MCU / Printerboard:
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue: I’m very new to all of this but it is my understanding that by using a Raspberry Pi Zero 2W and an ADXL345, I can run Klipper firmware on my Prusa. But before I even start to figure out the software, I need to know the wiring connections from the ADXL to the Pi.
Any help would be appreciated. Thank you!
…