After update v0.12.0-315-g8f361a15 klipper reports error

General Discussion
1

Basic Information:

Printer Model: Voron Trident
MCU / Printerboard: bigtreetech m8p 2.0
Host / SBC: orange pi CM4
klippy.log

I just updated klipper, then klipper reports "Unable to load module ‘led’“, which has never seen before. I just use white LED, didn’t install klipper-led-effect module, what might be wrong?
klippy (15).log (32.9 KB)

2

You’ve installed a file called nevermore.py which is the source of the error.

1 Like
3

Thanks a lot! I forgot about that.

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.