Basic Information: Printer Model: AnyCubic I3 Mega MCU / Printerboard: Raspberry Pi / TriGorilla klippy.log (50.4 KB) Describe your issue: TLDR: BLTouch only works every ~10 tries Hi there, i am trying to get a BL-Touch clone to work for BedMesh leveling. It is connected directly to the RPI…

[image] pcace: The Probe itself is around 2 millimeter above the nozzle in the retracted state. I would move the probe a little bit up. [image] Auto bed leveling with z limit switch [room]

Hi there, thanks a lot! i did make it to work, but i am kind of unhappy with the accuracy. probe accuracy results: maximum 0.975000, minimum 0.802500, range 0.172500, average 0.868250, median 0.832500, standard deviation 0.067897 for me that looks like i might be more acurate by using the good …

It seems your clone has a very bad quality. Typical standard deviation are at least a factor 10 smaller than your value, e.g. just tested on one of my printers: 16:37:45 // probe accuracy results: maximum 2.232681, minimum 2.225971, range 0.006710, average 2.228405, median 2.228233, standard de…

Maybe running 5V Hardware in 3,3V Pins?

BLTouch Clone only works sometimes (rarely)

General Discussion

hcet14 November 12, 2023, 1:25pm 2

I would move the probe a little bit up.

Topic		Replies	Views
BL Touch 3.1 issue (again...) General Discussion	4	2141	August 27, 2022
BLTouch failed to raise probe only in some points of the plate General Discussion	9	1521	February 3, 2024
BLTouch unrealistic return values General Discussion	3	1068	September 23, 2022
BLTouch failed to verify sensor state General Discussion	6	4207	February 20, 2024
BlTouch randomly crashes and its not the cable General Discussion	3	776	March 21, 2022

BLTouch Clone only works sometimes (rarely)

Related topics