Basic Information: Printer Model: TAZ 6 MCU / Printerboard: Duet 3 6HC, Canable (clone) and Toolboard 1LC Host / SBC: RPi 5 klippy.log (21.1 KB) I’m trying to setup a Canable (clone) with Duet 3 Toolboard 1LC. I have read through docs, forum and blog posts and I can’t figure out if I’m doing…

I am guessing your error is in your [extruder] config block: sensor_pin = toolboard_vref_scaled:PB9 that would be your main mcu - I guess you typoed a _ vs a : What is vref_scaled?! - I did not read that one until today EDIT: This was the wrong assumption.

Thank you for your reply. I’m new to klipper and basing my config off of someone else’s config ( generic Duet 3 6HC , sample duet3 1lc and printer-lulzbot-taz6-2017) which is a blessing and a curse, but as far as I understand toolboard_vref_scaled is aliased to the code below and vref_scaled has to d…

Ah ok looks like that is something used on Duet hardware. After reading the 6Hc and 1LC sample configs I guess [adc_scaled vref_scaled] is for your 6HC and [adc_scaled toolboard_vref_scaled] is for the 1LC Out of the schematics PB9 looks right Sry I will edit my comment with some strikethroughs …

It’s all good. =) I feel like the issue is trying to uses the Canable as a USB-to-CAN bus bridge, but I haven’t figured out the klipper setup to use the Canable with candlelight_fw (which seems to be possible if I’m reading things correctly). sudo ~/klippy-env/bin/python ~/klipper/scripts/canbus_qu…

Just use the Canable with candleLight. The only thing you need to configure is the can0 linux interface config. The Canable does not get mentioned in your printer.cfg this way - only your toolhead gets. If the candleLight Canable is connected, your can0 is as your initail post and klipper is stop…

Canable (clone) with Duet 3 Toolboard 1LC

General Discussion

Topic		Replies	Views
Duet 1LC Toolboard Compatibility General Discussion	4	115	February 5, 2026
Klipper & CAN & SHT36 won't work General Discussion	11	211	March 16, 2026
EBBCan - problem General Discussion	16	703	February 16, 2025
Uart reserved for can General Discussion	0	50	March 16, 2025
MCU Unable to connect Via Canbus General Discussion	18	1418	May 30, 2024

Canable (clone) with Duet 3 Toolboard 1LC

Related topics