Basic Information:
Printer Model:Voron 2.4 R2
MCU / Printerboard:MANTA m8p v2
Host / SBC cm4 emmc
klippy.log
klippy (1).log (192.9 KB)
I have the Orbiter SO3 tool board which is USB based and use the CAN on the Manta for the Cartographer scanning Z probe.
Is this even possible? or should I just get a can based toolboard?
Describe your issue: Klipper error: ex_uart_pin is reserved for CAN.
The SO3 USB tool board alias is ex_uart_pin: PD0
I use the Can from the M8P for the Cartographer Scanning Z probe only. the SO3 toolboard from LDO orbiter is USB based.
Is this a straight forward correction? or should I just get a can based tool board instead of the SO3 USB tool board. It just works so well with the Orbiter V3 Revo.
…