Basic Information: Printer Model: Voxelab Aquila (G32 chip) MCU / Printerboard: Radxa Zero (SBC) klippy.log - klippy.log (119.7 KB) Describe your issue: Cannot access ‘/dev/serial/by-id/’: No such file or directory I have followed all the posts and tried what I think is everything. I have tr…

What about uploading the klippy.log as well? Did you flash the correct firmware to your printer so it can be found?

Hi. Thanks for your reply. klippy.log uploaded to the OP. It’s here as well: klippy.log (119.7 KB) The file was found in this directory on the SBC (Radxa Zero): ~/printer_data/logs/klippy.log I flashed the firmware created. The config file for the Aquila printer printer-voxelab-aquila-2021.cfg …

A bit of an update. It was the micro-USB cable that wasn’t a data cable. So I can now connect to the Fluidd interface. I’m now facing another issue where the MCU is unable to connect! mcu ‘mcu’: Unable to connect Once the underlying issue is corrected, use the “FIRMWARE_RESTART” command to res…

Thanks @Sineos what I tried next was using the original 8Gb uSD card that came with the printer and Flashing the MCU with that. It worked. The 128Mb uSD card did not work. The 8Gb uSD card worked to flash the MCU. I have left the config as: [mcu] serial: /dev/serial/by-path/platform-xhci-hcd.0.a…

Cannot access '/dev/serial/by-id/': No such file or directory

General Discussion

Sineos March 20, 2024, 4:41pm 5

See Issues flashing the printer board for potential reasons and solutions.

Topic		Replies	Views
Problem mcu 'mcu': Unable to connect General Discussion	5	1889	August 9, 2024
MCU unable to connect, ls: cannot access '/dev/serial/by-id/*': No such file or directory General Discussion	9	4884	March 28, 2024
Mcu no such file or directory: ‘/dev/serial/by-id/’ General Discussion	2	2363	January 13, 2024
MCU errno2 no such file or directory General Discussion	4	552	March 14, 2024
"mcu" unable to connect General Discussion	4	565	July 25, 2023

Cannot access '/dev/serial/by-id/': No such file or directory

Related topics