Dear all, from my point of view, it’s an urgent safety issue that happens when you make system off in Klipperscreen, just when you select the on screen icon to shut power down, and confirm it, the raspberry or any other host computer you have, goes off, but the main card continues alive, in the most of the systems, I hope, at least in the ones I have, connected to PS_OFF_PIN, I have a device that shuts down the whole power supply inside the printer 3D, this device shuts the power down whenever there is a temperature alarm, or after a timeout, or following M81 Gcode, then I’m asking, for this pin to be inactivated, as soon as we order system down on klipperscreen