Basic Information:
Printer Model: voron 2.4
MCU / Printerboard: stm32f446
Host / SBC btt pi
klippy.log
klippy (21).zip (4.4 MB)
hey all, hate to beat on this old drum but i “think” ive tried everything short of a total reset or dirtying the klipper install.
according to some, the idea of noise on the can lines could have an impact so i have shielded and grounded those, slowed homing all the way down, ran a probe accuracy, have no bytes retransmit or invalid.
literally the only thing i did to start this off was swap out to a 0.6 nozzle and run a pid
if anyone has had some success… im paying attention
please and thankyou.