Dual BTT Smart Filament V2.0 Sensors?

Basic Information:

Printer Model: Homemade
MCU / Printerboard: BTT Octopus
Host / SBC Mainsail?
klippy.log nothing written yet

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

… So I am building a printer for work and we are going to run dual extruders and want to run dual filament sensors. We like the BT smart filament sensors. This takes up two “stop” connections per sensor. And it appears there are some macros or something running in the background of klipper. I am just digging into this, but is it possible to run two BTT smart filament sensors?

Thanks all!

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.