When I try to do ‘ls /dev/serial/by-id/', pi says "ls: cannot access '/dev/serial/by-id/’: No such file or directory". I tried lots of solutions, but none of them worked for me. What should i do? Ender3 V2 Raspberry Pi 3B Fluidd

I just bought another board - SKR mini e3 v3.0. Thanks for all people who helped me!

Typically this means your board’s firmware is not correctly working. Not following the instructions in the instructions / cfg Wrong firmware build options during make menuconfig Faulty USB connection Possible solutions: Closely follow Installation - Klipper documentation & klipper/printer-crea…

Thanks for your reply! Although I followed Klipper documentation and remade menuconfig, also using several other usb cables, it was still the same. Also, there was no lines like yours; instead, like this: [ 17.231491] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 17.231514] Bluetooth: BNEP f…

I think, the usb port of rpi might be broken since there was no change at dmesg. But, I don’t think the port could be broke so easily.

If you followed: Unplug USB Re-plug USB sudo dmesg and this is the result then you have you have a problem. Your board is not even recognized as USB device by the Linux operating system. Something with respect to USB must show up there or your board plays dead towards the Linux OS on your RPi. I…

Hmm… I see. Let me check this board. Thanks

In my experience, every controller board that uses the horrible ch340 USB chip tends to do these shnanigans. plug-unplug, wiggling the USB cable at the computer/PI end will eventually work. Be patient and good luck

Thanks benmed! But I already tried this, and failed…

Hi I had this same problem with Ender 3v1, but with a Creality V4.2.7 board. I had used octoprint successfully with klipper, and then tried fluiddpi and came to the same problem, I found out my problem:I changed usb cables during the switch and the usb cable is working fine in charging though, so i …

I got it to work by using the path instead of the ID. Just use ls /dev/serial/by-path/* and put the outcome in the mcu section after serial.

yeah, I had my printer working without updates for a year. yesterday I updated all from OS to FluiddPi to Klipper and after even printed successful 2h print. After rebooting via printer button (muster switch for pi and printer), I got same error Fluidd could not connect to host (Klipper) - though f…

E3V2 / 'ls /dev/serial/by-id/*' not working

General Discussion

Sineos October 3, 2023, 7:47pm 13

Check Debian 11 (Bullseye) udev bug - No board or serial found

Topic		Replies	Views
Can´t run ls /dev/serial/by-id/* General Discussion	6	15555	March 7, 2024
Ender3 v2 4.2.2 no usb id General Discussion	16	1415	September 8, 2023
Ls /dev/serial/by-id/* Is not being properly generated General Discussion	18	410	September 4, 2025
Where's my serial port for ender 3 v 2 .. 4.2.2 General Discussion	19	7628	May 14, 2024
/dev/serial/by-id/': No such file or directory General Discussion	7	860	January 16, 2025

E3V2 / 'ls /dev/serial/by-id/*' not working

Related topics