hello everybody I have a 3Zcorexy. I changed my bigtreetech Skr1.3 contorller board to Octopus ，my Printer_Config refer to BIGTREETECH-OCTOPUS-V1.0/BTT_OctoPus_Voron2_Config.cfg at master · bigtreetech/BIGTREETECH-OCTOPUS-V1.0 · GitHub , but the new board each layer will becoming more and more skewe…

Hello,bro I have solved my problem.But,maybe OCTOPUS（STM32F446） is not suitable for corexy+3z .I add skr1.3(lpc176) for my machine ，the same setting，it works well like before :joy: .THANK U for your kindly advice.

If all your other configuration settings are the same between the two boards, the first place to look is the drivers - are you using same drivers on the two boards? The other thing to confirm is the driver sense resistor values as those have direct impact on the drive current.

Thanks for your suggestion.I am using the same drivers and driver setting.But Driver_Current has been set to “auto”.Maybe，there are different influences between the two control board.I will try to solve it，follow to your advice. :blush: Thank you.

No problem, it was really just a shot in the dark. What do you mean by Driver_Current has been set to “auto”? There is no auto setting for stepper current, you have to choose the value based on your stepper motor ratings and printer requirements…

:disappointed_relieved: Some driver uart setting like tmc2209/2208， :disappointed_relieved:but this driver :disappointed_relieved: [image] ，SW6 for “Current auto tuning ” on datasheet .

Unfortunately external driver modules are beyond the scope of my experience with 3D printers. Especially if you use them in closed-loop mode. Perhaps someone else can help.

sorry，i am rebuilding the machine，log is missing. I wil finish it as soon as possible. :cold_sweat:

klippy.zip (660.6 KB) Hello, I’ve checked all the electronic wiring. But the problem still exists in the last printing. [cd6258a7a52c30e67eff731a2f323d1]

Each layer will becoming more and more skewed

General Discussion

Sineos July 21, 2021, 6:34am 5

@cheung please post your klipper log file.

Unable to obtain 'trsync_state' response - reproducible case

Topic		Replies	Views
Manta M8P V2 Slanted Prints General Discussion	20	1068	January 11, 2024
Layer shift after new MB and Klipper General Discussion	16	522	February 14, 2024
Facing layer shift after 3-4 hours of print General Discussion	24	981	December 12, 2023
Corexy Steppers Behaving like Cartesian Steppers General Discussion	13	762	November 17, 2023
Layer shifts on X axis only. Possibly after recent update General Discussion	8	757	February 24, 2023

Each layer will becoming more and more skewed

Related topics