Basic Information:
Printer Model: Elegoo Neptune 3 Pro
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
…Sorry for the basic information. I attached the klippy log so maybe you could help. I just changed firmware form Marlin to Klipper and the printer seems properly working. While I was printing it was appearing an error of shutdown for lost communication with MCU (this appeared with several print during and after the printing. Using AI and after further verification I discovered that the probe and endstop stepper_z are triggered even in home position. From GPT seems to be a relation but not sure if I have two separate problem or if connected. Thanks in advance for your help
klippy.log (4.2 MB)