Ender 3 S1 - Bed leveling / mesh

Basic Information:

Printer Model: Ender 3 S1
MCU / Printerboard: stm32f401xc
Host / SBC: Raspberry Pi
klippy.log (1.5 MB)

Describe your issue:

Hello everyone,

I’m having problems with my Ender 3 S1 that I can’t figure out with the bed. If I run the SCREWS_TILT_CALCULATE it tells me (img1)

The test should be wrong, but I have been adjusting the corners manually and the result despite these figures is (img2):

And with this test, I make a mesh but for example the base corner (front left) comes out as very raised instead of being the base… (img3)

Images (i can’t upload more 1 file)

Does this make sense?

I try to have the bed almost perfect to try to avoid the mesh as some parts give me problems and I wanted to check if it was the problem.

Thank you very much

And unfortunately, if I load the mesh, the test comes out worse.