Ender 3 v2, make menuconfig no showing STM32

General Discussion
1

Hi All,

I am trying to build a firmware for a ender 3 v2 (4.2.2) board, I was looking thru guides on the web and the “STMicroelectronics STM32” option is not available, what am I missing here ?

The only available options are:

$ make menuconfig

[*] Enable extra low-level configuration options
    Micro-controller Architecture (Atmega AVR)  --->
    Processor model (atmega2560)  --->
    Processor speed (16Mhz)  --->
    Communication interface (UART0)  --->
(250000) Baud rate for serial port
()  GPIO pins to set at micro-controller startup (NEW)
2

image
image877×202 7.87 KB

image
image811×69 3.47 KB

Cursor keys to navigate

3

ty @Sineos, that works, quite odd navigation :slight_smile: