Hi,
now had had the time to test something on my raspberry.
Done always with a fresh .config
Here my list:
v0.11.0-249-gba4eed175 (working)
v0.11.0-299-gb1f597c5 (working)
v0.12 (not working)
v0.13.0-181-ge1176e4df (not working)
v0.13.0-190 no bleeding edges (not working)
v0.13.0-190 (not working)
my MCU is a STM32F070CBT6
i also cleand up my printer.cfg. But during the test i always use the same printer.cfg
With the not working firmware my rasberry died exactly
after “Sending MCU ‘mcu’ printer configuration…”
So i have reset the raspberry agian.
The printer was not recognised by the raspberry so i have to powercyle th printer.
My gues , the sended configuration killed the printer firmware.
But this i can not debug.
What else i can do ?
by the way the printer is the same as Malyan M200 V3
Thanks