Error moonraker wheel for uvloop (pyproject.toml)

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Good afternoon everyone. I need help with any suggested solutions or links that might help.

I have a Banana Pi M2 Zero.

I’m trying to install Moonraker. (Klipper has already installed it)

However, in both “Armbian_23.11.1_Bananapim2zero_bookworm_current_6.1.63.img” and “Armbian_21.08.1_Bananapim2zero_bullseye_current_5.10.60.img”

It gets stuck in a loop “Building wheel for uvloop (pyproject.toml) … /” for a long time, nothing happens, and an error appears.

I’ve already tried almost everything available on the internet.

2

Well, it is hard to help without the error message, but it is an optional dependency, and can be disabled: moonraker/moonraker/server.py at 5b92e52e296d99ce43d1612ae83fb588ae47fc27 · Arksine/moonraker · GitHub

I guess your system just attempts to compile it from source, and there may not be enough memory to do so.

Hope that helps.